Difference between industrial designer and product designer is not precisely defined. There is a lot of discussions and misunderstandings about these two professions. What is the job of industrial designer and what is the job of product designer? This question if often asked from people, which want to hire someone to design a new product for them. Through this research, same real-life design contest is given to group of students from Faculty of Mechanical Engineering, Department of Mechanical Design, at Industrial design course and to group of students from Academy of Fine Arts, Department of Product Design as product design project. Goal of the contest was to design an upholstered chair for indoor use with a modern and refined style. Goal of this research was to find some unique characteristic of designs from industrial designers and product designers. Resulted designs were evaluated analysing the fulfilment of the requirements criteria defined by contest and analysing additional criteria, which is important for new product design. Analysing the resulted designs some important conclusions are made. Most important conclusion is that industrial designer can be product designer but product designer cannot be industrial designer. For product design, engineering knowledge is not necessary, but for industrial design, it is most important.

In this paper we will observe the model of competitive types and it will be analyzed using the nullcline method. It will be shown that this model has four points of equilibria, which are stable or unstable depending on the parameters a and b. The local stability of these points was investigated and global dynamics was determined using nullcline methods, that is, the bases of attraction of these points were shown.

This article presents architecture of integrated intelligent computer-aided design system for designing mechanical power-transmitting mechanisms (IICADkmps). The system has been developed in C# program environment with the aim of automatising the design process. This article presents a modern, automated approach to design. Developed kmps modules for calculation of geometrical and design characteristics of mechanical power-transmitting mechanisms are described. Three-dimensional geometrical parameter modelling of mechanical power-transmitting mechanisms was performed in the computer-aided design/computer-aided manufacturing/computer-aided engineering system CATIA V5. The connection between kmps calculation modules and CATIA V5 modelling system was established through initial three-dimensional models – templates. The outputs from the developed IICADkmps system generated final three-dimensional virtual models of mechanical power-transmitting mechanisms. Testing of the developed IICADkmps system was performed on friction, belt, cogged (spur and bevel gears) and chain transmitting mechanisms. Also, connection of the developed IICADkmps system with a device for rapid prototyping and computer numerical control machines was made for the purpose of additional testing and verification of practical use. Physical prototypes of designed characteristic elements of mechanical power-transmitting mechanisms were manufactured. The selected test three-dimensional virtual prototypes, obtained as an output from the developed IICADkmps system, were manufactured on the device for rapid prototyping (three-dimensional colour printer Spectrum Z510) and computer numerical control machines. Finally, at the end of the article, conclusions and suggested possible directions of further research, based on theoretical and practical research results, are presented.

The proven safe operation and the high availability of aerial ropeways is mainly thanks to their design. This is based on the manufacturer’s extensive experience as well as the strict application of the relevant rules and norms. In that regard, this paper describes an analysis of the haulage ropes on ropeways in case of accidental loads. In solving this problem, analyzed ropeway system with sufficient accuracy was modeled as a system with three degrees of freedom. For solving differential equations we have used the software “Wolfram Mathematica”. At the end of the paper, we discuss the results of the dynamic forces in the haulage ropes in a certain time interval, and the results of the safety factors which in this case are sufficient to ensure reliable operation of the system.