During sintering of the 2MgO-2Al2O3-5SiO2 system, cordierite, an attractive ceramic material because of its properties, is obtained. Effects of mechanochemical activation of stoichiometric mixtures, performed to investigate possibilities of lowering cordierite formation temperature during sintering, were monitored by thermogravimetric and differential thermal analyses. Specific surface areas of the mechanically activated powder mixtures were determined by the BET method. Kinetics of the specific surface area increase was analyzed using the Boltzmann model. It was confirmed that with activation time increase, temperatures of phase transformations were shifted to lower values and, according to FTIR analysis no significant changes occurred during material aging. According to the obtained results, it may be concluded that since mechanochemical activation has an influence on the treated powder mixture, lowering of the cordierite formation temperature during the sintering process is expected.

The low cement high alumina castable (LCC) studied in this paper was synthesised, cured and then treated at different sintering temperatures. Since any inhomogeneity introduced during the castable preparation can remain inside the material degrading its properties and therefore the quality during service life, particular attention was given to the processing procedure in order to produce the material with the optimum characteristics. Composition of the castable regarding particle size distribution was adjusted according to the Andreassen’s packing model. The samples were sintered at 1100, 1300 and 1600°C for three hours. Influence of the different sintering temperatures on the castable properties is discussed. Compressive and flexural strengths were deter mined by destructive testing method, while the water immersion method was used for determination of the bulk density and the water absorption. Changes of elastic properties and microstructure (porosity) were observed by the non-destructive testing methods, ultrasonic measurements and image analysis. Based on the results, it can be concluded that sintering temperature has strong influence on the properties of the LCC. Exceptionally good properties were obtained for the sample sintered at 1600°C, but it should be highlighted that the samples treated at 1100 and 1300°C were provided with good properties, too. This should not be neglected because of the energy saving importance, in cases where the material sintered at lower temperature satisfies the applica tion requirements.